KROHNE OPTISENS MAC 080 EN - Manual (Page 34)

6
OPERATION
34
OPTISENS MAC 080
www.krohne.com 01/2010 - MA MAC 080 R02 en
6.2 Menus of the converter (overview)
Press ↑ + ^ simultaneously for 5 seconds to enter the converter menu.
6.2.1 Menu "Setup"
Menu Description
Language Language Language Language English, German or Swedish.
Base unit Base unit Base unit Base unit Metric or US, selects mm or inch, m 3 or Gallon, °C or °F (the latest
can be overridden in the format menu below).
Date Date Date Date Show and change current date.
Time Time Time Time Show and change current time.
Contrast Contrast Contrast Contrast The contrast is compensated for temperature effects but may have to
be changed due to local lighting conditions or temperature.
Backlight Backlight Backlight Backlight "Auto" / "On"; Selects if the backlight of the display shall switch of
automatically eight minutes after last key was pressed
(recommended), or be on all the time.
No.Slots No.Slots No.Slots No.Slots "Auto", "4", "2" or "1"; Selects how many slots shall be shown in the
main menu. "1" shows only slot one, "2" shows slot one and two. "4"
shows all four slots. Auto selects the lowest possible from 1, 2 and 4.
Alarm type Alarm type Alarm type Alarm type "Level" / "Confirmed"; Select if an alarm shall go away when the level
is OK, or if it shall stay on until confirmed.
Formats Formats Formats Formats Press ^ to go to the "Formats" sub menu.
Temp °F or °C.
Date YY-MM-DD, MM/DD/YY or DD-MM-YY
Time HH:MM:SS or HH:MM
Exp.Module Exp.Module Exp.Module Exp.Module Installed module type, press ^ to set the node address if applicable.
Outputs Outputs Outputs Outputs Press ^ to go to the "Outputs" sub menu.
On fail "Freeze" / "2 mA"; Selects what shall happen with the analog output
signals if communication to a sensor is lost.
Out sig 1 4...20 mA or 20...4 mA
Out sig 2 4...20 mA or 20...4 mA
Out sig 3 4...20 mA or 20...4 mA (only with extra 4...20 mA module)
Out sig 4 4...20 mA or 20...4 mA (only with extra 4...20 mA module)
Integrate Integrate Integrate Integrate "Normal" / "Smart"; Smart shortens the integration time when more
than five consecutive samples are on the same side of the average to
get faster response to large changes.
Serial log Serial log Serial log Serial log "Off", "Slot 1 - Slot 4", "All" or "Slot1&2"; Selects a sensor to be
logged using the serial RS232 interface. The protocol is clear text.
This function is implemented for our service and may change in the
future without notice.
Interv.min Interv.min Interv.min Interv.min 0...999 minutes interval logging a value on the serial channel.
Choosing 0 will give a log value every second.
.book Page 34 Tuesday, January 19, 2010 1:07 PM