Operation – KROHNE PTIFLEX 2200 FOUNDATION FIELDBUS User Manual
Page 20
4
OPERATION
20
OPTIFLEX 2200 C
www.krohne.com
09/2013 - 4002573201 - AD FF OPTIFLEX 2200 R01 en
FD_CHECK_ACTIVE
FD_CHECK_ACTIVE
FD_CHECK_ACTIVE
FD_CHECK_ACTIVE
Check Active
Check Active
Check Active
Check Active
R
This parameter reflects the error conditions that are being detected
as active as selected for this category. It is a bit string, so that
multiple conditions may be shown.
Setting:
•
(00) Check Function
•
(01) Cond01
•
(02) Cond02
•
(03) Cond03
•
(04) Cond04
•
(05) Cond05
•
(06) Snapshot invalid
•
(07) Audio Signal Offset outside Range
•
(08) Reference Position outside Range
•
(09) Pulse Flange Lost
•
(10) No Probe detected
•
(11) Reference Lost Error
•
(12) Oscillator Frequency failure
•
(13) Temperature Above +75°C
•
(14) Temperature Below -35°C
•
(15) Overfill Warning
•
(16) Level Lost warning
•
(17) Temperature out of range (warning)
•
(18) Local operation
•
(19) Overfill Error
•
(20) Level lost error
•
(21) Temperature out of range Error
•
(22) Converter Voltage Error
•
(23) Converter ROM Error
•
(24) Converter RAM Error
•
(25) Converter EEPROM Error
•
(26) Sensor not compatible
•
(27) Internal Communication Error
•
(28) Sensor Voltage Error
•
(29) Sensor ROM Error
•
(30) Sensor RAM Error
•
(31) Sensor EEPROM Error
FD_CHECK_ALM
FD_CHECK_ALM
FD_CHECK_ALM
FD_CHECK_ALM
Check Alarm
Check Alarm
Check Alarm
Check Alarm
This parameter is used primarily to broadcast a change in the
associated active conditions, which are not masked, for this alarm
category to a Host System.
UNACKNOWLEDGED
Unacknowledged
RW
A discrete enumeration which is set to "Unacknowledged" when an
alarm occurs, and set to "Acknowledged" by a write from a human
interface device or other entity which can acknowledge that the
alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
ALARM_STATE
Alarm State
R
A discrete enumeration which gives an indication of whether the
alert is active and whether it has been reported.
Uninitialized
Uninitialized / Clear - reported / Clear - not reported / Active -
reported / Active - not reported
TIME_STAMP
Time Stamp
R
The time when evaluation of the block was started and a change in
alarm/event state was detected that is unreported. The time stamp
value will be maintained constant until alert confirmation has been
received – even if another change of state occurs.
Uninitialized
Setting:
MM / DD / YY (Month / Day / Year)
HH:MM:SS (Hour:Minute:Second)
Parameter
Parameter
Parameter
Parameter
DD name
Access Description and settings
Initial Value