KROHNE MFC 300 EN - Manual (Page 160)

9
DESCRIPTION OF HART INTERFACE
160
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
9.11.2 Basic-DD menu tree (details for settings)
3 Setup 7 HART 1 Device Info
2 Units (HART)
3 Formats (HART)
4 Preambles
4 Service 1 Service Access 1 Access Level HART
2 Service Access
1 Dynam. Variable
1 Measurements 1 Volume Flow / 2 Mass Flow / 3 Flow Velocity /
4 Temperature / 5 Density / 6 Diagnosis 1
Opt / 7 Diagnosis 2 Opt /
8 Concentration 1 Opt / 9 Concentration 2 or Diagnosis 3 Opt / 10 Concentration Flow 1 Opt /
11 Concentration Flow 2 Opt / 12 Totaliser 1 Opt / 13 Totaliser 2 Opt / 14 Totaliser 3 Opt
2 IO (Inputs/Outputs) 1 A Opt / 2 % Range A Opt / 3 B Opt / 4 % Range B Opt / 5 C Opt /
6 % Range C Opt / 7 D Opt / 8 % Range D Opt
1 Test
1 Simulation 1 Simul. Mass Flow Cust / 2 Simul. Density Cust / 3 Simul. Temperature Cust /
4 Simulation A Cust / 5 Simulation B Cust / 6 Simulation C Cust / 7 Simulation D Cust
2 Actual Values 1 Operating Hours / 2 Mass Flow / 3 Volume Flow /
4 Velocity / 5 Density / 6 Temperature / 7 Strain MT /
8 Strain IC / 9 MT Frequency / 10 Drive Level /
11 Sensor A Level/ 12 Sensor B Level/ 13 2 Phase Signal /
14 SE PCB Temperature / 15 BE PCB Temperature / 16 Act. Operat. Mode
3 Information 1 C Number / 2 SE Version / 3 Information Device / 4 Information Display
3 Setup
1 Process Input 1 Calibration 1 Zero Calibration Cust / 2 Zero Add. Offset Cust /
3 Pipe Diameter Cust / 4 Flow Correction Cust
2 Density 1 Density Cust / 2 Fixed Density Value Cust / 2 Density Ref.
Temp. Cust /
3 Ref. Density Slope Cust /
4 Density Calib. 1 1 Pt. Dens. Cal. Cust /
2 2 Pt. Dens. Cal. Cust /
3 Manual Dens. Cal. Cust /
4 Standard Dens. Cal. Cust /
5 DCF1 Rd / ... / 12 DCF8 Rd
3 Filter 1 Flow Direction Cust / 2 Press. Supp. Time Cust /
3 Press. Supp. Cutoff Cust / 4 Density Averaging Cust /
5 Low Flow Cutoff Cust
.book Page 160 Monday, February 6, 2012 11:01 AM