Alliance Laundry Systems CHM1766C - Manual (Page 17)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
15 F232224
The leftmost supply compartment (as seen from front
of machine), which can be used for detergent, flushes
during fill cycles whether Supply 1 option is enabled
or disabled. When Supply 1 option is enabled, Supply
1 (S1) output energizes and is available for external
chemical supply if desired. The Supply 2 option
controls the middle compartment, which can be used
for bleach. Supply 3 and Supply 7 options control the
rightmost compartment, which can be used for fabric
softener. Supply 4, Supply 5, and Supply 6 options
control external chemical supplies, as desired. Refer to
Table 3 for operation of each supply selection.
NOTE: For additional assistance, refer to
installation instructions.
Temperature Controlled Fill
38. Display shows temperature in degrees F or C.
Display will show degrees F if configured for
“FAr” in SETUP Mode, or degrees C if
configured for “CEL” in SETUP Mode. Range is
75°F to 200°F, or 00F (no heat for segment), or
25°C to 93°C, or 00C (no heat for segment).
39. Press the ∧ keypad to increase, or ∨ keypad to
decrease temperature. Temperature changes in
one-degree increments.
The control will energize heat and pause cycle timing
for up to 40 minutes until the programmed temperature
is first reached.
NOTE: If temperature is not reached after
40 minutes, control resumes cycle.
After cycle resumes, control will attempt to maintain
programmed temperature if it senses water in the
machine.
40. If display shows “drAI”/“nodr” during segment
programming, a drain step option can be selected.
41. Select “drAI” for a drain step followed by an
optional spin. Select “nodr” for no drain step.
NOTE: The machine will proceed directly to the
next segment if “nodr”.
42. Change the selection by pressing the ∧ or ∨
keypad.
43. Press START to continue.
44. If “drAI” is selected (or if your model does not
provide the option of selecting “drAI”/“nodr”),
the display will show “SPIn” one second, “tI
n E”
one second, and then the time for spin:
“00” (no spin) for 60-240 seconds IF you are in
Rinse 1 – 5.
45. If you are in Rinse 6, the time for spin will show
0 or 1-10 minutes.
46. Change the selection by pressing the ∧ or ∨
keypad.
47. Press START to continue.
IMPORTANT: The spin time in Rinse 6 is
programmed in minutes (0-10 minutes, in
one-minute increments). (Rinse 6 segment should
be used as the final rinse, even where there may be
fewer than four rinses. Program zero time for
preceding rinses you wish to exclude.)
48. Display shows temperature.
49. Exit PROGRAM Mode by moving the Program/
Run switch back to the right as seen from the
front of the machine.
NOTE: The SPIN indicator LED will automatically
light during the wash cycle when the last spin
programmed in a cycle is operating (regardless of
which segment).