KYORITSU 5020 Instruction Manual - Manual (Page 2)

Introduction
Thank you for purchasing KEW LOGGER 5010/5020.
Follow the procedure below and set time on the instrument before use.
1) Install the KEW LOG SOFT 2 and the USB Driver according to the
instructions written in the Install Manual for KEW LOG Soft 2.
2) Run KEW LOG SOFT 2 once install is completed. (Refer to “4. Start
“ KEW LOG SOFT 2”” in the Install Manual.)
3) Confirm that the LOGGER and a PC is firmly connected with a USB
Cable and click “Time Synchronizing”.
4) Confirm that the Logger connected with the PC is listed on the
“ List of detected loggers”. (The USB Driver might not be installed
correctly when a message “No Logger is detected.” is displayed.
Refer to the backside of the “Cautions for installing USB Driver
install” or “6. Trouble shooting” (P.8) of the Install Manual and
re-install the USB Driver.)
5) Click “Time Synchronizing” Button while the LOGGER is powered on
and checks are marked in the box for each connected LOGGER to
set time.
Read this manual and do your desirable settings. (Setting should be done
by using “KEW LOG Soft 2”. Settings for some Recording modes can be
done on the LOGGER.
Read through “1. Safety Warnings” in this manual before using the
LOGGER in order to ensure safe operation of the instrument.