Atmel 7698AAUTO01/07 - Manual (Page 11)

Using the ATAVRAUTO200
ATAVRAUTO200 User Guide 2-9
7698A–AUTO–01/07
2.5.1 Using the ATAVRAUTO900 Adaptator
An additionnal adaptator has to be used to program the board using IPS or JTAG mode.
The 10 pins connector is used for the JTAGICE mkII device and the 6 pins connector is
used for the AVRISP device. To plug the ATAVRAUTO900 connector to the board, the
arrow (on the adaptator) has to be in front of the point (on the board).
Figure 2-10. ATAVRAUTO900 Connection
Table 2-4. ICE Connector
PIN Function
1 TCK
2 GND
3 TDO
4 VCC
5 TMS
6 NRES
7 VCC
8 NC
9 TDI
10 GND
Table 2-5. ISP Connector
PIN Function
1 MISO
2 VCC
3 SCK
4 MOSI
5 NRES
6 GND
JTAGICE ISP
The arrow has to be in front of the point