NSi Industries DGS180 Old Series - Manual

NOTE: Unit can be fully programmed using battery
power only.
4. Reinstall unit by reversing step #1 above and con-
nect wires to unit as per suggested wiring dia-
grams. See illustration on enclosure label.
KEY FUNCTIONS
DAY/MONTH: Press to advance the day in the CLK
and SKIP modes. Press to advance the month in the
DATE mode.
HOUR/DATE: Press to set the Hours in the CLK
mode and in the Schedule SET mode. Press to
advance date in the DATE mode.
MIN/YEAR: Press to set the Minute in the CLK mode
and in the schedule SET mode. Press to advance
Year in the DATE mode.
OVERRIDE: Press to execute or terminate a signal.
MODE: Press to advance to next mode without
affecting the display information. Sequence is: RUN,
CLK, DATE, schedule SET, SIG 1, SIG 2, Skip (SP).
In the SET mode, unit automatically reverts to the
RUN mode if no entries are made for a short peri-
od of time.
SP DAY: Press to set or delete SKIP days (those on
which no signal schedule is executed)
SIG/SEC: Press to select signal 1, signal 2, or no
event - or to set the duration of signals in seconds.
ENTER: Press to store the displayed information into
memory. Information will not be stored until
ENTER is pressed.
NOTE: During settings, each press of the key will
advance one number. For rapid advance, hold key in.
2
DAY
MONTH
HOUR
DATE
MIN
YEAR
OVER-
RIDE
MODE
SP
DAY
SIG
SEC
ENTER
TORK DGS180
DIGITAL SIGNAL TIMER
24 HOUR WITH DAY OMIT
READ INSTRUCTIONS CAREFULLY BEFORE SETTING UNIT
FEATURES
Single channel signal timer with 2 duration settings
288 signals in 5 minute increments
24 Hour scheduling with day omitting
Battery back-up uses standard 9 volt non-recharge-
able (not supplied). Lithium averages 450 hours of
power outage; Alkaline averages 175 hours
Manual activation or deactivation of signal
Automatic daylight saving - user selectable
Automatic leap year compensation
AM/PM or 24 hour format - user selectable
INSTALLATION
UNIT IS TO BE INSTALLED BY A LICENSED ELECTRICIAN
1. To remove unit from enclosure: Push tab on right
to swing unit to the left and remove.
2. Mount the enclosure at eye level using screws or
other suitable fastening device. Bring supply and
load wires in through bottom or side knockouts.
DO NOT USE TOP.
Input wires to controller must be dedicated i.e. no
other loads connected to the same circuit.
3. Install a standard 9 volt lithium or alkaline battery
(not supplied) by gently squeezing the right side of
the battery cover on the front of the unit and pull
to open. Pull out the battery connector and con-
nect the battery. Reinstall battery cover. Lithium
should be replaced every 3-5 years, Alkaline
every year.