Precision Control Systems LineIR 5194 - Manual (Page 5)

106687-001 Rev.2 1-1
Section 1 – INTRODUCTION
The Model 5194 LineIR
®
Infrared line heater is designed for use in any application that
requires a clean, responsive, non-contact heat source.
Typical applications for the Model 5194 include:
Soldering
Unsoldering
Drying ink
Forming plastic
Curing epoxy
Heat treating
The Model 5194 includes the following major components:
Heater Module – The heater consists of a specular aluminum reflector that directs the
infrared energy generated by one ceramic end-seal ‘T-3 style’ quartz halogen lamp
factory-installed in the heater. Heated lengths of 2.56, 2.95, 5, 11, 16, 25, and 38 inches
(65, 75, 127, 279, 406, 635, and 965 mm) are offered for the Model 5194. Additional
lamps can be ordered separately from the heater.
Water Cooling – Adequate cooling water is required during operation of the Model
5194. Flexible tubing and plumbing fittings are supplied with each heater for easy
installation. Required cooling water flow rates are listed in Specifications.