Revo REP3AC24-8-4 - Manual

Specifications:
• 4 Amps 100 VA supply current.
• Eight (8) 24VAC individually fused outputs.
• Output fuses are rated at 3 Amps.
• Main fuse is rated at 5 Amps.
• Surge protected outputs.
• AC power LED indicator.
• Power ON/OFF switch.
• Spare fuses included.
• Unit maintains camera synchronization
• Ease of installation saves time and eliminates costly labor
Installation Instructions:
CCTV CAMERA & ACCESSORY POWER SUPPLY REP3AC24-8-4L
• (UL 2044)
1. Mount the REP3AC24-8-4L in desired location.
2. Slide switch to OFF position.
3. Connect green lead to earth ground. Connect the AC 115VAC 50/60Hz to the black and
white leads of the transformer.
4. Connect each camera to terminal pairs 1 to 8 marked (+ & -).
NOTE: It is important to measure output voltage before connecting devices. This
helps avoid potential damage.
5. Slide switch to ON position.
6. Green LED will illuminate when AC power is present.
7. Red individual LED’s will light when cameras or accessories are present & powered.
8. Upon completion of wiring, secure enclosure door with catch.
WARNING:
• To reduce the risk of fire or electric shock do not expose this unit to rain or
moisture. This installation should be made by qualified service personnel and
should conform to all local codes and in accordance with the National Electrical
Codes. For continuous protection against hazard, replace only with same type and
rating of fuse.
• The power cord included with this power supply is intended for temporary testing
purposes only.
• Before testing, ensure that the enclosure has been properly grounded as per local
and National Electrical Codes.
• This product must be installed by qualified personnel in accordance with all local
and National Electrical Codes.
Outputs:
• Input 115VAC 50/60Hz, 0.9 Amps
Primary:
P31002-11/05