Revo REVDN700E-2 - Manual (Page 10)

INSTALLATION – VP DOME
1. Loosen the four torx screws located midway up the front of the housing leaving the
screws intact in the front portion. (Fig. 1)
2. Drill the mounting location, using the Drilling guide. (Fig. 3)
3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping screws are
supplied. Only use if they are suitable. (Fig. 3)
4. Close the housing using the loosen torx screws. (Fig. 2)
Torx screws
Torx screws
(4x)
Seal around
the housing
base tightly
using
Figure 1
Figure 2
* Label is attached at the bottom.
10