Alpine TMX-R705 - Manual (Page 6)

FR
ES
DE
SE
IT
5
-EN
Closing the Monitor Display
NOTE
The TMX-R705 is a precision device. With careful
handling, its performance can be maintained at a high
level for a long time.
1
Press the OPEN/CLOSE button of the main unit
or press the POWER button, press and hold the
OPEN/CLOSE button of the supplied remote
control for at least 2 seconds.
The unit beeps 3 times and closes the monitor
automatically.
Then the power of the monitor turns off.
NOTE
Since this is an overhead monitor, the display will be
lowered when opened and raised when closed.
If the monitor touches an obstacle while it is being
raised, the unit will stop immediately.
Should this occur, remove the obstacle and press the
OPEN/CLOSE button again to close the monitor.
Opening the Monitor Display
NOTE
The TMX-R705 is a precision device. With careful
handling, its performance can be maintained at a high
level for a long time.
1
Press the OPEN/CLOSE button of the main unit
or press the POWER button, press and hold the
OPEN/CLOSE button of the supplied remote
control for at least 2 seconds.
The unit beeps 3 times and opens the monitor
automatically.
Then the power of the monitor turns on.
An SPST (Single-Pole, Single-Throw) switch (sold
separately) can be added to simplify this procedure.
Then, you can simply place it in the OFF position
when you leave the vehicle. Turn the SPST switch
back ON before using the TMX-R705. For connecting
the SPST switch, refer to the Installation.
• After turning the system off, a slight ghost of the
image will remain temporarily. This is an effect
peculiar to LCD technology and is normal.
• Under cold temperature conditions, the screen may
lose contrast temporarily. After a short warm-up
period, it will return to normal.
NOTES
• Since this is an overhead monitor, the display will be
lowered when opened and raised when closed.
If the monitor touches an obstacle while it is being
lowered, the unit will stop immediately. Should this
occur, remove the obstacle and press the OPEN/
CLOSE button again to close the monitor.
If you press the POWER button or the OPEN/CLOSE
button while the monitor is being opened or closed,
the monitor stops opening or closing and cannot be
closed automatically. In this case, press the POWER
button or the OPEN/CLOSE button again to close the
monitor.
• When the movable monitor is opened, do not place
any object on the monitor and be careful not to bump
or apply any pressure to the monitor while it is open.
This can cause damage to the mechanism.
• Under low ambient temperature conditions, the
display may be dark for a short period of time
immediately after the power is turned on. Once the
LCD has warmed up, the display will return to
normal.
• The TMX-R705 draws minimal current even when its
power switch is turned off. If the switched power
(ignition) lead of the TMX-R705 is connected directly
to the positive (+) post of the vehicle's battery, the
battery may be discharged. If this lead is unswitched,
it must be disconnected from the battery post should
the vehicle be left unused for an extended
period of time.