Seametrics EM 101 v.1 - Manual

1- 800 -975 - 8153
E M 1 0 1
LOW-FLOW MAGNETIC FLOW METER
INSTRUCTIONS
EM 101-025
EM 101-038
EM 101-050
GENERAL INFORMATION
SIZE NOMINAL FULL SCALE MIN. FOR 1% ACCURACY LOW FLOW CUTOFF
L/MIN. GAL./MIN. GAL./HR. L/MIN. GAL./MIN. GAL./HR. L/MIN. GAL./MIN. GAL./HR
-025 3.8 1 60 .38 0.1 6 .04 .009 .54
-038 11 3 180 1.1 .3 18 0.1 .025 1.5
-050 30 8 480 3.0 .8 48 .25 .065 3.9
FLOW RANGE
SPECIFICATIONS
M AT E R I A L S
Wetted Materials - ● Body: Kynar™ PVDF
● Electrodes: Platinium coated titanium
● Internal Seals: Viton™
Housings - ● Primary Element: Fusion coated aluminum
● Control / Display: Polycarbonate
P O W E R
● 115 VAC, 60 Hz, optional 220 VAC/50Hz
A C C U R A C Y
● +/-1% of reading, above 10% of full scale
● +/-3% of reading, below 10% of full scale
M A X I M U M F L U I D T E M P E R AT U R E
● 185º F
M A X I M U M P R E S S U R E
● 150 PSI (@ 75º F)
M I N I M U M C O N D U C T I V I T Y
● 20 micro Siemens
O U T P U T S
● 4-20 mA, 0-5 Volts (both isolated)
● Frequency to 9999 pulses per gallon, Isolated 10 mA, 30 VDC
● High alarm, low alarm relay, Isolated
(100 mA, 110 VAC/VDC)
The EM101 is a small plastic-bodied electromagnetic flow meter,
in nominal maximum flow rates of 1, 3, and 8 gpm. Capable of measur-
ing the pulsating flows from air and solenoid-driven metering pumps,
the meter is primarily designed for electrically-conductive chemicals. In
addition to measuring and displaying flow rate and total flow, this unit
has a variety of outputs. For continuous transmission of a flow signal,
there is a 4-20 mA, and 0-5 Volt signal, and a frequency signal propor-
tional to flow. In addition, there are relay alarm outputs for low and
high flow with user-set flow levels.
EM101 LOW FLOW MAGNETIC FLOW METER INSTRUCTIONS
AR
CH
IVE
D
(Includes Dates Before 1
1/06)