SHIMPO DT-5TP - Manual

Instruction Manual Instruction Manual Instruction Manual Instruction Manual Instruction Manual
P P P P Panel Mount T anel Mount T anel Mount T anel Mount T anel Mount Tachometer achometer achometer achometer achometer
Model DT Model DT Model DT Model DT Model DT-5TP -5TP -5TP -5TP -5TP
Features Features Features Features Features Dimensions (mm) Dimensions (mm) Dimensions (mm) Dimensions (mm) Dimensions (mm)
Installation Installation Installation Installation Installation
Operational P Operational P Operational P Operational P Operational Precautions recautions recautions recautions recautions
! If the unit is used in a caustic environment, we
suggest you use a NEMA 4X enclosure.
! Keep unit free of vibration and shock.
! When installing unit, keep power and sensor wires
separate. Tie cable shield to terminal E (earth ground).
! After inserting wires, tighten terminal screws securely.
This microprocessor-controller digital tachometer can be
used in any direct rpm application where no special gears
or generators are required. Here are some of its outstand-
ing features:
! Mounts easily — no brackets or screws required.
! Any AC line voltage between 85 and 264 (50/60 Hz)
can power the unit.
! Parameters are easily set via front panel membrane
switches.
! Parameter settings are stored in a nonvolatile
memory.
! Pulses per revolution range is 1 - 9999.
! Signal LED on front panel.
Our 1/8 DIN case design eliminates the need for brackets
and screws for installation. With the tachometer in a level
position, insert it into the panel cutout. Gently push the
face of the unit until the front bezel locks into place. If the
tachometer case is loose, adjust the integral bracket with
the enclosed tool.