SHIMPO 933 - Manual (Page 24)

24
Choose the Learn menu item under the Configuration menu. The dialog shown in Figure
15 is displayed. The user must tell the system the type of switch contact (NO/NC) and
whether bounce will be tested. With the switch attached and in its fixture, press the OK
button. A relatively slow test of the switch is repeated 10 times until a cumulative
average is obtained. These test results are downloaded and used to calculate the
configuration parameters. The configuration data dialog box is then displayed. Inspect
and modify and parameters as necessary. Click OK to send these values to the LCTS.
Figure 15.
Model 933A Application Software Learn Switch Dialog