SUOMY Mr Jump - Manual (Page 23)

Only the correct assembly of the cheek pad and the correct positioning of the strap will
assure the proper operation of the retention system.
If this doesn’t happen and the removable cheek pads don’t work correctly, do not use the helmet
and contact Suomy authorized personnel only.
Internal central padding : fitting and removal
Removal – see fig. 5A
The internal padding is fixed to the helmet through 2 back stud buttons and in the front part
through a click-in tongue. There are also two side tongues that fix the internal padding to the
polystyrene.
Remove the removable cheek pads (refer to paragraph CHEEK PADS). Release the back stud
buttons and release in the front part of the polystyrene, the click-in tongue from its seats. Slide
out the two side tongues that fix the internal padding to the polystyrene. Remove the internal
padding.
Caution: to avoid damaging the internal lining, before removing the padding, make sure
the tow back stud buttons were released.
USER’S INSTRUCTIONS
ENG
21
figure 5A