TEKTON 4677 - 25 ft. x 3/8 in. Retractable Air Hose Reel - Manual (Page 9)

page 9
Adjusting Recoil Tension
Hose reel is shipped with spring tension properly set. Be aware that spring tension is calibrated to retract
entire length of air hose. If you are working with only part of the air hose length, recoil action may seem slower
than expected. However, if you feel hose rewinds too quickly or too slowly, you can easily adjust the tension of
the main recoil spring by simply turning the reel drum to a new "home" position.
DO NOT SET TOO MUCH TENSION IN SPRING. Damage to spring could result.
1. Disconnect incoming air supply.
2. Pull out about two feet of hose and lock reel in position.
3. Remove hose stopper. Pull hose backward through hose guide.
4. While firmly gripping edge of reel drum, turn reel clockwise (as viewed from air inlet side) just enough to
release locking pawl.
DO NOT LET GO OF REEL DRUM, or it will spin uncontrolled until all spring tension is lost.
To Increase Tension: Turn reel drum clockwise until desired tension has been added. Lock reel in nearest
locking position.
To Decrease Tension: Allow reel drum to slowly turn counterclockwise until extra tension has been
released. Lock reel in nearest locking position.
5. Feed hose through hose guide. Re-attach hose stopper.
6. Connect incoming air supply.
Adjusting Hose Stopper Position
The hose stopper determines the length of hose that remains outside of reel. To adjust stopper position,
first pull hose out past the desired position of hose stopper. Lock reel in position. Loosen (but do not
remove) both stopper bolts just enough so stopper can slide along hose. Move stopper to desired
position. Tighten stopper bolts until hose stopper cannot slide. Do not overtighten bolts.
Loosen but do not
remove bolts
DE
CR
EA
SE
IN
CR
EA
SE
See label
DO NOT OPEN THIS COVER!
Spring motor inside is under tension.
CAUTION
Desired length
of hose