Aiwa NSX-AJ50 - Manual (Page 18)

18
ENGLISH
SETTING THE TIMER
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1 Press one of the function buttons to select a
source.
2 Press TIMER repeatedly until 5 appears on the
display.
When using the remote control, press TIMER while pressing
SHIFT.
Time and audio source name flash alternately.
3 Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or a a a a a .
Turning MULTI JOG changes both the hour and the minute.
f or g is also available in place of MULTI JOG. Holding
these buttons down will vary the time rapidly.
4 Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated period.
The duration can be set between 5 and 240 minutes in 5-
minute steps.
f or g is also available in place of MULTI JOG.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or
a is pressed within 4 seconds after
step 4.
TIMER
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP while pressing SHIFT.
2 Within 4 seconds, press f f f f f DOWN or g g g g g UP
to specify the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
MULTI JOG is also available in place of
f or g .
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEP oFF”
appears on the display.
Specified time