West Control Solutions N6500 - Manual (Page 2)

NOTES
1.
Modifies the actual process variable value in the following manner:
Offset PV = Actual PV + PV Offset
The offset PV value is used for all PV-dependent functions (control, display, alarm).
NOTE: Choose this value with care. This is, in effect, a calibration adjustment.
There is no indication when this parameter is in effect (i.e. has been set to
a non-zero value).
2. The cycle time value required is dependent upon the process being controlled and the
type of output being used. For a Relay output, the cycle time should be as large as
possible (whilst remaining compatible with the process control requirements) to
maximise relay life. For an SSR Drive output, the cycle time may have a lower value.