ZAGG invisibleSHIELD Dry - Manual

CONTENTS:
INSTRUCTIONS: BEGIN WITH FRONT PORTION / SCREEN
NASDAQ : ZAGG 801.263.0699 WWW.ZAGG.COM
INSTALLATION SQUEEGEE
LOGO BACKING -----------
invisibleSHIELD DRY -----
ALIGNMENT FILM -----------
APPLICATION FILM -------
invisibleSHIELD DRY
®
- INSTALLATION INSTRUCTIONS
For best results please review install video at: www.zagg.com/dry
*Tips for an easier installation are located below the steps, please read before beginning
For best results please review install video at:
www.zagg.com/dry
Pull fro m Her e
STEP 1: Lay the invisibleSHIELD DRY down on a flat surface
with the Logo Backing facing up. Starting from the bottom,
hold the Application Film down with your finger and use
your other hand to slowly peel the Logo Backing away from
the Application Film. Be sure the invisibleSHIELD DRY and
Alignment Film remain adhered to the Application Film.
STEP 2: With the speaker end pointing toward you, adhere
the “ALIGN HERE” portion of the invisibleSHIELD DRY /
Alignment Film to the device, holding the rest of the
invisibleSHIELD DRY away from the surface of the device.
Keep the film away from the screen of the device until it is
applied by the squeegee. With one steady forward motion,
use the squeegee to apply the invisibleSHIELD DRY /
Alignment Film. Begin at the speaker end and move toward
the bottom of the phone.
STEP 3: After the invisibleSHIELD DRY is aligned and applied
on the device, run the squeegee firmly across the Application
Film to smooth out any remaining bubbles. Carefully peel
the Application Film and the Alignment Film away from the
invisibleSHIELD DRY. THE DEVICE IS READY FOR USE
IMMEDIATELY. (Any remaining micro-bubbles will disappear
over the next 24 to 48 hours as the invisibleSHIELD DRY
continues to settle onto the device.)
BACK INSTRUCTIONS: Gently remove the Logo Backing
from the Application Film. Position the invisibleSHIELD
DRY over device. If the alignment is not perfect, simply peel
it off and re-apply. Using your thumbs and fingertips, apply the
invisibleSHIELD DRY to your device, moving from the center
to the edges. When satisfied,carefully peel the Application
Film away from the invisibleSHIELD DRY and smooth out
any remaining bubbles with your thumb. (The matte back
will fully cure within 24-48 hours.)
GLOSS FRONT MATTE BACK
---------- LOGO BACKING
--- invisibleSHIELD DRY
----- APPLICATION FILM
SPECIAL INSTALLATION TIPS
For best results, make sure environment is clean; including hands and work surface.
Slow, deliberate, application with squeegee will provide fewer initial micro-bubbles & better final results.
Watch lines & edges of device while applying. If alignment is skewed, or large bubbles appear under
surface during application, invisibleSHIELD DRY can be slowly peeled back & the process started again.