Aleco Clear-Flex II Truck Mounting System - Manual

MaxBullet Truck Mount System
Installation Instructions
PARTS INCLUDED: TOOLS NEEDED: (1) 8 ft. MaxBullet Mounting Bar
(2) L-brackets
(4)
1/4 ” x 1 1/2 ” Self-Tapping Screws
(4) 1/4 ” x 3/4 ” Bolts
(4) Locknuts
Scratch-Guard Material & Hi-Viz Safety Rings *
Pen or Pencil
Drill with
1/4 ” Bit
Adjustable Wrenches
Saw (as needed)
Ladder
Tape Measure
Utility Knife
INSTALLATION
*
Number of strips and safety rings dependent upon strip size and overlap
Step 1
For trailers with
roll-up doors, locate the stud
closest to the door opening
in the rear of the trailer.
NOTE: For trailers with swing-
doors, mount bar as close to
top of trailer as possible.
Be sure to leave room for
mounting bar and bolts,
approximately 1” from top.
Figure A
Step 3
Measure width
of trailer and, if necessary,
cut mounting bar to length
using saw.
Step 4
Place mounting
bar on L-brackets and using
L-bracket as a template, mark
holes and drill with a
1/4 ”
drill bit.
Figure C
Step 2
Using the self-
tapping screws provided,
install L-bracket on stud as
close to roller track as possible
without impeding move-
ment of door on track.
Repeat for other side.
NOTE: Remember to leave
room for mounting bar.
Figure B
Step 6
Install PVC strips
using preferred amount of
overlap. Refer to diagram on
referse side of this page for
details on strip placement.
Figure E
Step 7
Place Hi-Viz
safety rings on bullets
where strips overlap
(see Figure F).
Step 8
The strips should
be trimmed to leave 1/4 ” of
clearance from the floor
surface. Use a common utility
knife to score and then tear
the strips by hand.
Figure F
Step 5
Mount bar
to L-brackets using the
provided bolts and lock-
nuts.
Figure D
P/N 477504
0506
FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE
2720 E. Avalon Ave. Muscle Shoals AL, 35661 Phone (256) 248-2402 or toll free 1-800-633-3120
Fax: 1-800-750-9616 email: [email protected] web: www.aleco.com
STUD