Aleco AL-125-1 - Manual

Installation Instructions
PARTS INCLUDED: TOOLS NEEDED: AL1251 Impact Door Panel(s)
Adjustable SpringLoaded Hinges
Tension Rod & Tension Pins
832 x 1/2” Flat Head Phillips Screws
#8 x 3/4” Flat Head Phillips Wood Screws Marker to Mark Holes
Drill
Screwdriver
Step Stool or Ladder
Tape Measure
STEP 1
Release spring tension from each hinge barrel by
inserting provided tension rod into the tension
adjustment hole. Rotate in direction of arrow as
shown in Illustrations A and B at right and remove
tension pin.
STEP 2
Attach adjustable springloaded hinges to
door(s) as shown in Illustration C.
NOTE: For best alignment of double doors,
install hinges with tension adjustment UP on
one door panel and tension adjustment
DOWN on the other door panel.
STEP 3
Align door panel with centerline of door jamb
and mount using appropriate fasteners for the
application. Allow approximately 1/2” of clearance
between the top of the door panel and the
bottom of the door opening.
P/N 994211
1010
1
FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE
2720 E. Avalon Ave. Muscle Shoals AL, 35661 Phone (256) 248-2402 or toll free 1-800-633-3120
Fax: 1-800-750-9616 email: [email protected] web: www.aleco.com
AL-125-1
INSTALLATION
Illustration A
Illustration C
(Shown with tension adjustment up)
Illustration B