Audient ASP8024 Dual Layer Control Module - Manual (Page 11)

11
and then return by entering setup again, you will notice that your setting has
been automatically saved.
Using the page keys, page to the right and ensure that Use DHCP is set to
NO .
Page right again to reach the IP address screen and set the IP address to
192.168.0.100 (default) using the encoders, then move to the fourth page,
and check that the subnet mask is set to 255.255.255.0.
IP Address set to 192.168.0.100
Subnet Mask set to 255.255.255.0
Port set to 1212
Press the setup key again to exit setup and your setting will be saved.
Now power down the console and restart your PC.
Once booted, ensure that the AuNet application is running and open on your
DAW machine. Next, power up the console.
After the console boots, it should be picked up by AuNet (you may have to
repeat the power down / restart process if you are experiencing difficulties).
AuNet should indicate detection of the console and should also show you the
serial number of the console. Select the console and click on the connect
button to the bottom right.