Audio2000's AKJ780E - Manual (Page 16)

Basic Connections
13
5. : CONNECTING EFFECTS USING THE EFFECT INSERT
1.
2.
3.By using the built-in EFFECT INSERT you can add external effects to vocals and/or guitar or keyboard or
microphone without compromising the quality of the original signal.
Connect one end of the ¼ inch stereo audio cables to the GUITAR EFFECT, KEYBOARD EFFECT, or
MIC EFFECT inserts on the rear panel of the AKJ780E.
Connect the other end of the ¼ inch stereo audio cables to the sound effect device.
The effect insert is a break point in the input channel signal path, It allows the signal to be taken out from this
, through an external equipment such as a Limiter,Compressor,Equalizer, Effector,and then back to the
,the input jack can be used with
phone jack,the signal will be sen out through TIP of the
phone jack and back to the through RING of the phone jack.
AKJ780E
AKJ780E
AKJ780E
¼ inch t ¼ inch
¼ inch
3.¼ INCH PRE- Out Connections:
Connect one end of the ¼ inch audio cables to the left and right PRE-OUT jacks on the AKJ780E.
Connect one end of the ¼ inch audio cables to the left and right AUDIO/LINE/AUX INPUT jacks on
the external device.
●
●
PRE-OUT