Anton/Bauer ULTRALIGHT 2 UL-2 - Manual (Page 6)

Stud Mount Application
1/4-20 Screw
ACCESSORIES
UL2 WEDGE
The UL2 Wedge is developed specifically for use with the Anton/Bauer Ultralight 2 on-camera light.
The UL2 Wedge provides the Ultralight 2 with an additional 20º of down angle lighting for shooting
extreme close up camera shots (less than 3 feet).
A Universal mounting design allows quick adaptation to cameras using either ¼-20 Stud Mount or
Shoe typing lighting mounts.
UL2 WEDGE STUD MOUNT APPLICATION
1. Position the base of the UL2 wedge directly over the camera’s ¼-20 Stud Mount.
2. Fasten the UL2 wedge to the camera mount using the supplied ¼-20 Phillips screw. (Do Not
Overtighten)
3. Attach the Ultralight 2 to the UL2 wedge by threading the UL2’s ¼-20 stud directly into the mating
hole on the ramp of the UL2 wedge.
UL2 WEDGE SHOE MOUNT APPLICATION
1. Slide the base of the UL2 wedge into the camera Shoe Mount. (Insert at the front of camera -
towards the lens.)
2. Fasten the UL2 wedge to the camera shoe using the supplied 5/16-24 slotted screw. (Do Not
Overtighten as this will cause damage to the camera mount)
3. Attach the Ultralight 2 to the UL2 wedge by threading the UL2’s ¼-20 stud directly into the mating
hole on the ramp of the UL2 wedge.
XL-WEDGE
Same as the UL2-Wedge except that it is 3 inches longer. Should be used to clear Shotgun Mics and
Wide Angle Lens. Will also allow the UL2 to clear the shoulder strap without interference.
Shoe Mount Application
5/16-24 Screw