Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 7)

Installation Manual
PLACE THE ENDPOINT ONTO THE METER
1 Place the endpoint gasket on the rear of the endpoint
a Place the two slots through the guide pins
b Place the gasket so that the rounded part goes under the endpoint rear drive shaft See
Figure 6
Figure 6: Placement of gasket on rear of endpoint
2 Place three (3) screws (10-24 X 1") into the endpoint See Figure 7
Screws
Figure 7: Screw placement
3 Place the endpoint on the gas meter so that the endpoint drive tab connects with the gas meter gear See Figure 8
Endpoint drive tab Endpoint drive tab connects
with gas meter gear
Figure 8: Endpoint drive tab connect with gas meter gear
4 Screw the endpoint onto the gas meter Tighten the screws to about 4 inch-pounds See Figure 9
Figure 9: Screw endpoint onto gas meter
Page 7 July 2014