Agilent Technologies 16048A User Manual
Operation and service manual
Advertising
Table of contents
Document Outline
- Agilent 16048A Test Leads
- Agilent 16048A Test Leads
- Notices
- Notices
- The information contained in this document is subject to change without notice.
- This document contains proprietary information that is protected by copyright.All rights are rese...
- Agilent Technologies Japan, Ltd.
- Component Test PGU-Kobe
- 1-3-2, Murotani, Nishi-Ku, Kobe-shi, Hyogo, 651-2241 Japan
- Copyright © 1990, 1998, 1999, 2000
- Manual Printing History
- Safety Summary
- Safety Summary
- The following general safety precautions must be observed during all phases of operation, service...
- Agilent Technologies assumes no liability for the customer’s failure to comply with these require...
- NOTE 16048A comply with INSTALLATION CATEGORY I and POLLUTION DEGREE 2 in IEC61010-1. 16048A are ...
- • Ground The Instrument
- • Ground The Instrument
- • DO NOT Operate In An Explosive Atmosphere
- • Keep Away From Live Circuits
- • DO NOT Service Or Adjust Alone
- • DO NOT Substitute Parts Or Modify Instrument
- • Dangerous Procedure Warnings
- Certification
- Warranty
- Warranty
- This Agilent Technologies instrument product is warranted against defects in material and workman...
- For warranty service or repair, this product must be returned to a service facility designated by...
- Agilent Technologies warrants that its software and firmware designated by Agilent Technologies f...
- Limitation of Warranty
- Exclusive Remedies
- Assistance
- Safety Symbol
- Safety Symbol
- General definitions of safety symbols used on the instrument or in manuals are listed below.
- Instruction Manual symbol: the product is marked with this symbol when it is necessary for the us...
- WARNING This warning sign denotes a hazard. It calls attention to a procedure, practice, conditio...
- CAUTION This Caution sign denotes a hazard. It calls attention to a procedure, practice, conditio...
- NOTE Note denotes important information. It calls attention to a procedure, practice, condition o...
- 1 Operation
- 1 Operation
- This operating note provides complete information on the 16048A Test Leads. The 16048A is shown p...
- Product Description
- Specifications
- Typical Characteristics
- Compensation for Fixture Residual Impedance Error
- 2 Service
- 2 Service
- Maintenance
- Maintenance
- An exploded view of the 16048A (for parts identification) is shown in
- Figure 2-1 Parts Identification
- Figure 2-1 Parts Identification
- <グラフィック>
- Table 2-1 Parts Identification
- *: Not separately replaceable.