Crystal XP2i-DP Digital Differential Pressure Gauge - Manual (Page 3)

Overview  1
XP2i Programming Instruction Manual
Overview
—
IntroductIon
Thank you for choosing the XP2i Digital Test Gauge from Crystal Engineering Corporation. Your XP2i is a combination of leading edge technology and rugged
industrial design.
Your XP2i can be configured through the use of ConfigXP™ software available from Crystal Engineering. Your personal computer can disable, enable, or
modify a variety of features of your XP2i. Look for the
logo for programmable features, like:
•
A user defined pressure scale, and/or disable unused pressure units
•
Password protection to prevent unauthorized changes
•
Disable keypad recalibration, peak button, and/or units button
•
Expand or decrease allowable Zero range
•
Set the gauge to a different density of water factor (4°C, 60°F, or 68°F)
•
Store a 12 digit ID or tag number in non-volatile memory
•
Adjust calibration values
We hope your XP2i meets your expectations, and we’re interested in any comments or suggestions you may have.
You can send us a note at:
[email protected] Many features in this and our other products are a direct result of your comments!
The XP2i can be connected to a personal computer via RS-232, using an ordinary DB9 extension cable (male DB9 for the XP2i connection, female DB9 for the
PC side). The interface lets you record displayed readings and recorded peaks. The data string always includes the pressure units.
The XP2i can be operated remotely, as if you were pressing the buttons. You can use a simple terminal program to send the commands, or, you can incorpo-
rate them into your own software program.
I/o Settings
The serial interface settings are:
Baud rate data Bits Parity Stop Bits Flow control
9600 8 None 1 None