Crystal nVision Lab Reference - Manual (Page 2)

1 Unclip the Rear Bezel from the Rear Panel Assembly of the nVision
Lab Reference.
2 Place nVision Lab Reference into Rack Panel opening (from the front as
shown in diagram) until the front bezel stops against the Rack Panel.
3 Remove the four (4) mounting screws on the Rear Panel Assembly of
the nVision Lab Reference.
4 Gently pull Rear Panel Assembly aside without disconnecting either
the interconnect cable or BARO tube from the inside components.
Note: BARO port and connected tube will only exist on units that
have the BARO Module option.
5 Slide Flange Bracket into exposed channel of Enclosure extrusion as
shown on the drawing. Note that the Flange Bracket must face toward
Rack Panel. Position completely against the rear side of the Rack Panel
and install M4 set screws to secure.
6 After M4 screws are secure, install and tighten the set screws
into the brackets.
7 Reinstall the Rear Panel Assembly using the four (4) mounting screws
and replace the rear bezel.
8 The rack mounted nVision Lab Reference is now ready to be
installed into the Rack.
nVision
Lab Reference
Rear Bezel
Rack Mount Kit
P/N 4302
Mounting
Screws
(4 PL)
Set
Screws
(4 PL)
M4 Screws
(4 PL)
not provided
nVision
Lab Reference
Rack Panel
(19 inch shown)
not provided
Flange
Bracket
nVision
Lab Reference
Rear Panel
Assembly
© 2013 Crystal Engineering Corporation
708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701 4566. C