FUTEK IPM650 Series - Manual (Page 9)

9 9
The decimal point can be moved by
selecting it fi rst and turning it into a
number, and then selecting another
digit to change it into a decimal point.
Sensitivity (+) must be entered. If
only one direction is selected, then
sensitivity (+) will be applied to both
directions of output or negative
direction output.
Sensitivity is the sensor’s output level,
such as mV/V output, and is found on
the calibration certifi cate.
Pressing back without saving will
prompt to exit without saving. Enter can
be used for Yes, and Back for No.
Current profi les cannot be set up
manually and must be set up using the
Live Calibration feature in the profi le
setup.
Full bridge sensor type is for mV/V
output sensors.
TIPS FOR SETTING UP A PROFILE
332179_Futek_IPM650_r2.indd 9 332179_Futek_IPM650_r2.indd 9 9/11/13 9:32 AM 9/11/13 9:32 AM