FUTEK IHH500 Series - Manual (Page 10)

10
TEDS is a small chip that can store a sensor’s calibration information. The IHH500 can read it upon power up, or by loading it
through the menu, and setup a profile with the stored information.
TEDS MENU
1. Menu
2. TEDS Data
3. TEDS Device — Will show information about TEDS chip.
4. TEDS Pages — Shows programmed information stored
in chip.
5. Load Data — Will load TEDS information into IHH500.
6. Auto Detection — Sets the IHH500 to automatically
load TEDS information upon power on.
CHANNEL SELECT (CALIBRATION PROFILE SELECT)
1. Menu
2. System Setting
3. Channel Select
4. Use the left and right arrow key to choose the desired
channel.
5. Enter to load Channel or Profile.
TEDS and Channel Select
TEDS calibration information can be
viewed upon loading TEDS, either during
a power on or while selecting Load Data
under the TEDS menu. The TEDS chip should be placed within
5ft. of the IHH500 sensor connection
to maintain proper power. Typically the
TEDS chip is placed in the sensor binder
connector. An auto-calibration may be performed
when loading TEDS information, or a
new channel or profile.
TIPS FOR USING TEDS AND CHANNEL SELECT