Kaman KD-2440 - Manual (Page 5)

4 5
KD-2440
Specifications
ELECTRICAL
INPUT
Voltage:
Regulated 12 VDC to 24 VDC
Current: Fuse limit input current from power source to 11 mA, .28W maximum at full load
ANALOG OUTPUT
Current (Full load): 4.2 mA maximum
Impedance: 50 ohms
Voltage: 0-22 VDC minimum with 24 VDC input
0-10 VDC minimum with 12 VDC input
SWITCHED OUTPUT
Opto-Isolated
Load Current: 100 mA maximum AC or DC
Load Voltage: 30V rms, 42.4V peak, or 60Vdc
On Resistance: 30 ohms minimum / 50 ohms maximum
Switch Point Hysterisis: 0.56% of full scale for 9C sensor, and 0.97% of full scale for 5CM sensor, using
24Vdc input on 4130 steel.
FREQUENCY RESPONSE
0-10 KHz (± 3db)
RESOLUTION
Better than 0.008% of measuring range using a 5CM sensor on a 4130 steel target at mid scale, and
12Vdc input
ENVIRONMENTAL
ENCLOSURE RATINGS
Sensor:
IP 67
Electronics: IP 61
OPERATING TEMPERATURE RANGE
Sensor and cable: 0°F to 400°F (-18°C to 205°C)
Electronics: 32°F to 150°F (0°C to 66°C)
STORAGE TEMPERATURE RANGE
Sensor and cable: -60°F to 400°F (-52°C to 205°C)
Electronics: -58°F to 212°F (-50°C to 100°C)
THERMAL DRIFT
Less than 0.22% per °C of full scale for sensor, electronics or system.
9C Sensor Specifications:
SMA Male Connector
RG179 coax cable
1.030 (26.16)
1.250 (31.75)
96 (2438)
.320 Dia
(8.13)
3/8-24 THD
Target Material 9C Sensor Measuring Range
Non-Ferrous (Aluminum) 0 - 0.175 in. (0 - 4.45 mm)
Non-Magnetic Steels (304
Stainless)
0.025 - 0.200 in. (0.64 - 5.08 mm)
Magnetic Steels (4130) 0.040 - 0.275 in. (1.02 - 6.99 mm)
5CM Sensor Specifications:
120 (3048)
M5 x 0.8 THD
SMA Male Connector
RG179 coax cable
1.85 (47.0)
1.60 (40.6)
.160 Dia.
(4.1)
Target Material 5CM Sensor Measuring Range
Non-Ferrous (Aluminum) 0 - 0.100 in. (0 - 2.54 mm)
Non-Magnetic Steels (304
Stainless)
0.010 - 0.125 in. (0.254 - 3.18 mm)
Magnetic Steels (4130) 0.015 - 0.150 in. (0.38 - 3.8 mm)
Dimensions are in inches (millimeters)
Home