JJC RM-E6A - Manual

1
JJC RM-E6A
Infrared Remote Control Instruction
Thank you for purchasing JJC RM-E6A Infrared Remote Control. For the best performance, please
read this instruction carefully before use. RM-E6A replaces Canon RC-1 Infrared Remote
Control
z Identifying the buttons
S
Button for camera shutter.
2S Button for 2 seconds delay shutter.
z To Use RM-E6A Remote Control
1. Before using the remote, please remove the plastic separator (if your remote control has) from
the battery holder.
2. Mount the camera on a tripod (recommended) or place the camera on a stable, level surface.
3. Set your camera for delayed remote or quick response remote
1
.
4. Aim the remote control at the infrared receiver on the camera (usually within +/- 20 degree of
the lens axis, from the left to the right and from the top to the bottom) and press the
shutter-release button on the remote control (when using the remote outdoors, make sure that
the subject is not backlit and that the line of site between the transmitter and the infrared
receiver is not blocked by the lens or other obstacles).
5. How the camera focuses and shoots depends on the option selected for your camera's custom
setting. For further information, check your camera's manual.
6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the
front end of the remote control when operating.
z Specification
1
For more information please read your camera instruction.