Milestone XProtect Professional 2014 - Manual (Page 79)

Milestone XProtect ® Professional
2014
Administrator's Manual
www.milestonesys.com 79 Advanced configuration
Record all frames on event
Allows you to make exceptions if you have selected to record
keyframes only. Select this check box to record all frames when an
event occurs and until another event occurs. Use of this feature
requires that events have been defined, and that you select start
and stop events in the neighboring lists.
Use the Configure events list, located below the other fields to
define events that suit your needs.
Start Event
Use when recording on Event or Motion Detection & Event.
Select required start event. The camera will begin recording all
frames when the start event occurs.
Stop Event
Select required stop event. The camera will again only recording
keyframes when the stop event occurs.
Dual stream:
This feature is only available on cameras supporting dual stream.
Name Description
Enable dedicated live stream
This additional stream feature lets you use the alternative stream of
the camera. It enables two independent streams to the recording
server
—a stream for live viewing and another stream for recording
purposes, with different resolution, encoding, and frame rate.
Stream
Select the type of the live stream. Stream settings for viewing live
video and for recording video may very well be different in order to
get the best result.
Resolution Select the resolution of the camera.
FPS Select the camera's live frame rate per second (FPS)
Manual recording
When you configure video and recording (see "About video and recording configuration" on page 64),
you can specify certain properties for many cameras in one go. In the case of manual recording, it is
because the properties are shared by all cameras.
When manual recording is enabled, XProtect Smart Client users with the necessary rights can
manually start recording if they see something of interest while viewing live video from a camera which
is not already recording.
If enabled, manual recording can take place even if recording for individual cameras (see "Recording"
on page 91) is set to Never or Conditionally.
When started from XProtect Smart Client, such user-driven recording always takes place for a fixed
time, for example for five minutes.