Milestone System Watch - Manual (Page 7)

Milestone System Watch Manual
www.milestonesys.com 7 Set up System Watch
Set up System Watch
Once you have installed System Watch, you add an
XProtect surveillance server by indicating its DNS
name or IP address. Click Test to see if a connection
has been successfully established between System
Watch and your XProtect surveillance system.
You add an ADAM 6060 box by indicating its DNS
name or IP address. Note that ADAM 6060 boxes are
enabled by default. If you do not have an ADAM
6060 box connected to your system, Milestone
recommends that you clear the check box enabling
the ADAM box, since your system will keep using
system resources while trying to connect to the
ADAM 6060 box.
Click Show to see an overview of alarm states
(on/off), or click Test if you want to test the
connection between System Watch and your ADAM
6060 box.
Under Advanced, you can set:

The number of seconds to pass before the
System Watch contacts the XProtect server.

The number of successive errors needed for
an alarm to be triggered.

TCP port number for the ADAM 6060 box.

DNS name or IP address of a Syslog server.

TCP port number for the Syslog server.
Once you have finished setting up the XProtect surveillance server, click OK. System Watch now
keeps you updated on the status of the XProtect surveillance server. If you need to, you can edit
existing servers or add more XProtect surveillance servers at a later stage.