Milestone Panasonic WV-CU950 Controller Smart Client Plug-in - Manual (Page 11)

XProtect
®
Panasonic WV-CU950 Controller Smart Client Plug-in
www.milestonesys.com Page 11 Configuration & Licensing
•
Make sure camera number (shortcut) is defined, which are used to identify each camera. This can be
defined in the Management Client (XPCO)/Management Application(XPE), each camera's shortcut
number is specified in the Shortcut field in the Client .
To access the Client tab, select the required camera in the overview pane, then select the Client tab in
the properties pane.
•
Configure action from the setup module. This action is set to CAM by default.
•
The function can be activated by pressing a number followed by pressing CAM on the device. E.g. press
65 and CAM will switch to camera with shortcut ‘65’.
Example of Select Monitor
To configure “Select Monitor” function,
•
Make sure view number (shortcut) is defined, which are used to identify each view. This can be defined
in the Smart Client on the Setup tab.
Specify the required shortcut number in the Shortcut field.