Milestone Basis+ 6.5 - Manual (Page 10)

9
1. Open the Administrator application (double-click the
Administrator desktop shortcut or select Start > All
Programs > Milestone XProtect Basis+ >
Administrator).
2. In the Administrator application, click the Import
DLKs… button.
3. Browse to the location at which you have saved the
.dlk file.
4. Select the file, and click Open.
5. All DLKs from the file are now imported in one go.
Adding Devices
In XProtect Basis+ you add devices (IP video camera devices
or IP video encoder devices) rather than actual cameras. This
is because devices have their own IP addresses or host names.
Being IP-based, XProtect Basis+ primarily identifies units on
the surveillance system based on their IP addresses or host
names.
Even though each device has its own IP address or host name,
several cameras can be attached to a single device and thus
share the same IP address or host name. This is typically the
case with cameras attached to video encoder devices. You can
of course configure and use each camera individually, even
when several cameras are attached to a single device.
Before adding a device, make sure you have configured the IP
address, password, etc. for the device as described by the
manufacturer. When ready, do the following to add the device:
1. In the Administrator application, click the Add Device…
button.
2. Type the device’s IP address, or select the Use DNS
host names check box and type the device’s host
name.