NUUO 8000HD SERIES - Manual (Page 9)

Intelligent Surveillance Solution
page - 8
Hardware Installation
Step1:
Insert the card onto an empty PCI-e slot. Connect the Audio/Video
Cable to the connector.
Note 1:
The audio input connectors are with red wires and marked of “A”
on them (such as “A1/9”); the video input connectors are with black wires
and marked of “V” (such as “V8/16”).
Note 2: You need to power down the PC before you insert the card.
Step 2: Connect the Watchdog wire to the reset connector on the main
board.
Note: With the Watchdog Wire
connected, the system will be restarted if
any abnormal conditions.
Step 3:
Turn on your PC and start Windows.
Step 3:
Insert the included Software CD into CD-ROM.
Step 4:
Refer the section Driver Installation on page 18 to install driver.
Step 5:
After driver is installed, restart your PC.
Optional I/O Card:
refer to the figures on the following pages.
Step 1: Fix the IO card onto your PC.
Step 2: Connect the Capture Card and the I/O Card with an included
ribbon cable (2.54mm IDC cable).
Note 1: The default configuration of blue slide switch on I/O Card as
below.
Note 2: Before install SCB-7100 Series cards, please connect HDMI cable
first then it would be easier to fix the card onto the PCI-e slot.
Note 3: Some chassis may not be suitable for installing SCB-7100 series due
to the original design, please check the dimension of the chassis before
installing.