Resize 4232-a-2.pdf, 4232-a – PATLITE BK User Manual

Page 2

Advertising

CH8

CH3

・
・
・

SD card

Card slot

BK-24□

BK-100□

BK-220□

6-5-1.Bit input (Sound group selection switch:A to H)

By short-circuiting the COM terminal and each CH terminal, the sound is played that

corresponds to each channel.
●

If there is short circuit of the two or more CH terminal and COM terminal

at the same time, the sound of the CH with a larger number is played.
Priority order of CH CH8＞CH7＞・・・・＞CH2＞CH1

6-5-2.Binary input (Sound group selection switch:P)

By short-circuiting the COM terminal and eash from CH1 terminal to CH6 terminal, the

sound among the No.1 to No.32 is played, depending on the state of each short circuit.
（

Refer to the corresponding table for binary input）

CH2

CH1

CH2

CH3

CH4

CH5

CH6

input

CH input

Sound

playing

CH input

Sound

playing

Playing lag time

About 300ms

Playing lag time

About 300ms

Input timing

Playing CH

CH1

CH2 CH3

CH8 CH3

□109.8

Input timing

Sound number of CH1

Sound number of CH2

Sound number of CH3

Sound number of CH4

Sound number of CH5

Sound number of CH6

Sound number of CH7

Sound number of CH8

Playing sound

No.

Corresponding table for binary input

＊

The “1” in this table means short circuit of the COM terminal and CH terminal.

＊

In the case of input contacts which are not described in the table or CH7,8, the sound

“5.Rapid Hi-Lo” is played.

12 - 24V DC

100V AC (50/60Hz)

220V AC (50/60Hz)

10.8 - 26.4V DC

100V AC ± 10%

220V AC ± 10%

Maximum 481mA

Maximum 145mA

Maximum 71mA

45m/s

'08.12.NHI

4232-A

530g ±10%

350g ±10%

Playing while short-circuiting between each CH terminal and COM terminal.

-20 ∼ 50℃

1MΩ and above ( At 500VDC ),Between charged metal part and non-charged metal part.

500VAC for 1 min.

1000VAC for 1 min.

1500VAC for 1 min.

Between charged metal part and non-charged metal part.

19.6m/s

62.8

17.2

□120

Sound No.

CH1CH2CH3CH4CH5CH6

Sound groups

●

Sound Chart type E(BK-□E)

Sound List

6-3.How to Combine Sounds

When the sound group H is selected, sounds can be chosen from
the 32 sounds and combined freely using an SD card.

●

Items prepared by customers

SD card (Type: SDV-128P Sold separately), Personal computer, SD card Reader/Writer

6-3-1.Creating the sound combination data

By using a personal computer, data consisting of different sounds is created

①

Connect SD card Reader/Writer to PC, and then insert an SD card.

SD card Reader/Writer

SD card

Personal computer

②

In the My Computer of the PC, open the drive into which the SD card is inserted.

③

Within the window opened, click with the right mouse button, and point New Document

and then choose Text Document.

* The name may vary such as notepad depending on the OS and its version.

④

Change the file name of the created text document to

【

OTO-LIST.txt 】

* Use half-size upper- or lowercase letters for the file name.

If the extension ".txt" is not displayed when the text document is created,
change the file name to [ OTO-LIST ].

Enter the number of the sound (see 6-2. Selecting a Sound Group) you want to combine
into the text document created in ④ and store it in the SD card.
* Enter the sound number with half-size numbers of 16 digits.

When a combination of the following sounds are to be created with the type BK-□A.

[Example]

CH1. Beep

(slow intermittent horn)

CH2. Amaryllis CH3.

Synthesized Piano

CH4. Grandfather’s Clock CH5. The camptown Races CH6. Shutter

CH7. Cuckoo CH.8 Mary had a little Lamb

Input the number [0125073120022119] in the text file, and store the file.

6-3-2.Transferring the sound combination data

The sound combination data created in "6-3-1. Creating the sound combination data" is transferred

to this product.
①

Turn on the power of this product, and check if the COM terminal and CH terminal is not

short-circuiting.
②

Open the front cover, and insert the SD card, in which the data created in "6-3-1. Creating the

sound combination data" is stored, into the card slot. And then, data transfer is started automatically.
③

When transferring the sound data is completed, it is informed by the sound ‘Pee.’Then, pull out

the SD card.
* The writing completes in 1 second or less. When it is informed by the sound ‘Pipipipi’ or there is
no reaction, the data transfer is not normally completed.Confirm the contents of data and operation
procedure.In addition, take note that if the volume control is set to the minimum, the informing sound
cannot be heard.
⑤

Set the sound group selection switch to H, and confirm the sound of each channel .

●

As for the SD card, use the type SDV-128P sold separately. Operation is not guaranteed

if an SD card of any other type is used.
●

When formatting the SD card, do it in FAT16.

●

When inserting the SD card, pay attention to the orientation of the SD card. And do not forcibly

insert the SD card into the card slot. Doing so may cause damage to the SD card and/or
the product.
●

Pay attention that no foreign object enter into the card slot.

Other Precautions

6-4.Adjusting the Sound Volume

The sound volume can be adjusted using the
volume control. Use a flat-blade screwdriver with
the blade thickness of 1.0mm or thinner for turning
the volume control.

●

Turn the volume control lightly. It may be damaged if a torque of 0.3N・m or more is applied.

●

If sound volume is increased, sound cracking may occur depending on a sound.

●

Even if the volume is set at the minimum level, the sound condition may not become silent,

depending on the environment of usage.

Volume
larger

Volume
smaller

1mm

Other Precautions

Information

6-5.How to Play sounds

When the COM terminal and the terminal CH 1 - CH 8 are short-circuited after turning on the power,
the sound of the channel of the selected group is played.
●

Sound is played while the terminals are short-circuited.(Level hold input)

●

When this product is operated by turning on the power, it takes about 1 second to play a sound.

●

Although pop noise is sometimes generated at ON/OFF of power supply,

it is not a failure.

Information

●

If the product does not operate correctly even after it is properly installed and handled,

contact a branch office or the technical support printed on the last page.

Contents of trouble

Points to be checked

Method of action/treatment

Is the power supplied?
Are the COM terminal and CH terminal short-circuited correctly?

Are the COM terminal and CH terminal short-circuited correctly?

Is the volume control not set to the minimum?

Is the power supplied?

It is correctly selected with the sound group selection switch?

Confirm the wiring.(5.How to perform wiring)

Adjust the volume.(6-4.Adjusting the Sound Volume)

Is the volume set to the minimum level or not?

Confirm the sound group selection switch.(6-2.Selecting a Sound Group)

Confirm the wiring.(5.How to perform wiring)

Sound is not played

Is there a text document stored in the SD card?

Is the SD card correctly inserted?
Is the SD card of our company’s optional item used?

Confirm a text document in the SD card.
(6-3.How to Combine Sounds)

Confirm the SD card.
(6-3-2Transferring the sound combination data.)

SD card is not read.

Is the location of the stored file correct?

Are the file name and the content of the text document correct?

A diffferent channel

is played

7. Before You Request a Repair

●

Please note that we will not be held responsible for the failure or damage caused by handling

the product in ways not observing the warnings or cautions contained in this document.
●

Please note also that the contents in this document may be changed for improvement

without notification in advance.

Model

Rated Voltage

Current Consumption

Voltage Range

CH input method

Mass

Sound Pressure

Level

RH 85% or lower (no condensation)

Indoor: Normal, reverse, and lateral direction are possible

(Normal direction only in places where water may be splashed on it). Outdoor: Normal direction only

Operating Temperature Range

Number of playing channels

Relative Humidity

Mounting Direction

IP54 (When the panel is mounted in normal direction; Front only)

Protection Level

Resistance to Vibration

Withstand voltage

Insulation resistance

8. Specifications

【

External view】(mm)

Maximum 95dB (Fit the product on the plate of □300mm, and measure the level with the sound 5."Rapid Hi-Lo"
at the distance of 1m from the center of the product, in the front direction. Volume is adjustable.
*The sound pressure level may be lowered depending on the sound and environment of usage.
*The sound pressure level of type BK-24 may be lowerd in case of usage by 17V DC or less.

Bit input (In case of setting of sound group from A to H) /Binary input(In case of setting of sound group from A to H)

Bit input : 8 channels / Binary input : 32 channels

Ｆ

Ｇ

Synthesized Bell

Group

Synthesized Melody

Synthesized Piano

Call sign

Annie Laurie

London bridge is falling down

Mary had a little Lamb

Minuet

Fur Elise

The camptown Races

Synthesized Bell

Synthesized Piano

Melody Chime

Alarm Clock

CH 1

Group

Stutter (rapid intermittent horn)

Bell (clear highpitched bell)

Inverted Revellie

The sound 5."Rapid

Hi-Lo"

32 sounds of the

Sound 01∼32 are

playable by using CH

1∼CH 6.

(Binary input)

Galactic Motor

Symphony No.40

Ｉ∼O

Alarm Clock

Grandfather s Clock

Two Tone

Ringing Hi-Lo

Synthesized Piano

Call sign

Ringing Hi-Lo

Synthesized Bell

Call sign

The camptown Races

Galactic Motor

Amaryllis

Ringing Phone

Chime

Alarm Clock

Chime

Grandfather s Clock

Fur Elise

Alien Chatter

Train Ride

London bridge is falling down

Falling Crystals

Galloping Hi-Lo

Mary had a little Lamb

Inverted Revellie

Minuet

Annie Laurie

Amaryllis

Symphony No.40

Galactic Motor

CH 7

The camptown Races

Chime

Ave Maria

Ａ

Ｅ

Ｄ

Ｃ

Ｂ

CH 1

CH 8

CH 5
CH 6

CH 2

CH 8

CH 7

CH 3
CH 4

CH 4

CH 3

CH 6

CH 5

Ｈ

Rapid Hi-Lo

Beep (slow intermittent horn)

Two Tone

CH 2

Stutter (rapid intermittent horn)

Chime

Mary had a little Lamb

Ave Maria

Yelp (rapid siren)

Ringing Phone

Stutter + Bell

Rapid Hi-Lo

Inverted Revellie

Annie Laurie

Galactic Motor

Beep (slow intermittent horn)

Stutter + Bell

Stutter (rapid intermittent horn)

10 Synthesized Melody

London bridge is falling down

Bell (clear highpitched bell)

Chime

Ringing Phone

Mary had a little Lamb

Yelp (rapid siren)

Call sign

Two Tone

28 The camptown Races

07 Synthesized Piano 15

Alien Chatter

Synthesized Bell

Falling Crystals

Ringing Hi-Lo

Galloping Hi-Lo

Alarm Clock

Minuet

Symphony No.40

For Elise

32 Grandfather s Clock

Ave Maria

Rapid Hi-Lo

Train Ride

Melody Chime

Amaryllis

Advertising

Popular Brands

Popular manuals