PNI TCM - Manual (Page 35)

PNI Sensor Corporation DOC#1014688 r06
TCM User Manual – July 2013 Page 30
6.4.3 Current Configuration
These indicators mimic the pertinent selections made on the Configuration tab.
6.4.4 Options
This window indicates how many samples are to be taken and provides real time heading,
pitch, and roll information if “HPR During Calibration” is set to <On>, both as defined
on the Configuration tab.
Audible Feedback
If selected TCM Studio will give an audible signal once a calibration point has been
taken. Note that an audible signal also will occur when the <Start> button is clicked,
but no data will be taken.
6.4.5 Clear
Clear Mag Cal to Factory
This button clears the user’s calibration of the magnetometers. Once selected, the
module reverts to its factory magnetometer calibration. To save this action in
nonvolatile memory, click the <Save> button. It is not necessary to clear the current
calibration in order to perform a new calibration.
Clear Accel Cal to Factory
This button clears the user’s calibration of the accelerometer. Once selected, the
module reverts back to its factory accelerometer calibration. To save this action in
non-volatile memory, click the <Save> button. It is not necessary to clear the current
calibration in order to perform a new calibration.