Ampeg SVP1600 - Manual (Page 7)

7
System Block Diagram:
SVP1600 Stereo Bass Power Amplifier
SPEAKER
OUTPUT A
SPEAKER
OUTPUT B
SPEAKER
OUTPUT B
SPEAKER
OUTPUT A
SPEAKON ®
SPEAKER
OUTPUT
MONO BRIDGE
1+
2+
1- 2-
SPEAKON ®
SPEAKER
OUTPUT A
SPEAKON ®
SPEAKER
OUTPUT B
1+
2+
1- 2-
LIMIT
DEFEAT
POWER
AMP A
STEREO/
DUAL MONO
MONO
BRIDGE
POWER
AMP B
POWER AMP A
INPUT / MONO
SENSITIVITY
CHANNEL A
SENSITIVITY
CHANNEL B
POWER AMP B
INPUT
LIMITER
LIMITER
1+
2+
1- 2-
POWER AMP A
PARALLEL
OUTPUT
POWER AMP B
PARALLEL
OUTPUT
LIMIT
LED
B
LIMIT
LED
A
Operation: Stereo Mode:
SVP1600 7 43565 15531 9 SVP1600
(21) SERIAL# BMCDN20083
Line: 120V Freq: 60 Pwr: 1.4kVA
OUT
FROM STEREO PREAMP OR
STEREO EFFECT'S LEFT OUTPUT
FROM STEREO PREAMP OR
STEREO EFFECT'S RIGHT OUTPUT
STEREO/
DUAL MONO
LEFT CHANNEL
CABINET(S)
2 OHMS
MINIMUM
RIGHT CHANNEL
CABINET(S)
2 OHMS
MINIMUM
Set the Stereo/Dual Mono / Mono Bridge switch to the Stereo/Dual Mono position (switch out).
Connect a shielded signal cable from the Left Output of your Stereo Preamp or Stereo Effect to the Power Amp A Power Amp Input jack.
Connect a shielded signal cable from the Right Output of your Stereo Preamp or Stereo Effect to the Power Amp B Power Amp Input jack.
Connect a speaker cable from the SVP1600’s Power Amp A Speaker Output jack to the input jack(s) of the Left Channel speaker(s).
Connect a speaker cable from the SVP1600’s Power Amp B Speaker Output jack to the input jack(s) of the Right Channel speaker(s).
NOTE: The Speakon
® cable must be wired as follows: 1+ = hot, 1- = ground.