Alpine TDM-7582 - Manual (Page 19)

17
-EN
1 Antenna Receptacle
2 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power
antenna, if applicable.
NOTE
This lead should be used only for controlling the vehicle's
power antenna. Do not use this lead to turn on an
amplifier or a signal processor, etc.
3 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's
fuse box or another unused power source which
provides (+) 12V only when the ignition is turned on
or in the accessory position.
5 Fuse Holder (15A)
6 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle's battery.
7 Ground Lead (Black)
Connect this lead to a good chassis ground on the
vehicle. Make sure the connection is made to bare
metal and is securely fastened using the sheet metal
screw provided.
8 Power Supply Connector
9 Right Front (+) Speaker Output Lead (Gray)
! Right Front (–) Speaker Output Lead (Gray/
Black)
" Right Rear (–) Speaker Output Lead (Violet/
Black)
# Right Rear (+) Speaker Output Lead (Violet)
$ Left Rear (+) Speaker Output Lead (Green)
% Left Rear (–) Speaker Output Lead (Green/Black)
& Left Front (–) Speaker Output Lead (White/Black)
( Left Front (+) Speaker Output Lead (White)
) DIN Connector
Connect this to the DIN connector on the CD
Changer.
~ Rear Output RCA Connectors
RED is right and WHITE is left.
+ DIN Extension Cable
NOTE
For some installations, an L-type DIN connector would
simplify installation. Use the Alpine 4910
02
Adapter
(Sold Separately) if your changer did not include an L-
type DIN.
, RCA Extension Cable (Sold Separately)