ROTRONIC CF8-W-Disp-CO - Manual (Page 2)

Dokument
IMA 208 Rev
1 Page
2 (4)
Fig. 2
11 Lid locking screw
12 Wall plate
13 Screw to hold the wall plate
14 Marking to drill hole for PG7
15 Marking to drill hole for PG9
Wall Mounting Instruction
1. Dismount the wall plate. The sensor is delivered with the wall plate mounted.
The wall plate has to be removed before the sensor is mounted onto the wall.
Unscrew the screw on the side of the box. See figure 3.
2. Screw the wall plate onto the wall. The sensor should be mounted 1 to 1,8 m
above the floor. The wall plate has holes for three screws. Drill holes for 3,5mm
screws and put dowel into them. Dowels and screws 3,5 x 25mm are included
in a plastic bag
3. Attach the sensor box to the wall plate. It is done by a snap-in fitting. The wall
plate has three hooks that fit in holes in the sensor box. Fasten the screw on the
side of the box.
4. Electrical cable entry. The box has a factory mounted cable entry bushing in
dimension PG9. Never feed more than one cable through each cable entry
bushing, or else gas might leak through!
The lid can be locked with the screw (11) at the bottom of the sensor box.
3
8
,5
(1,
5)
1
0 (0
,3
9)
9,
5 (
0,
3
7
)
85 (3,35)
142 (
3,
5
8
)
Please note! Normally the PCB should not be removed from the
housing. If for some reason the PCB must be removed it must be
handled carefully and protected from electrostatic discharge.