Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems - Manual (Page 62)

Page 62 SDAP Series PD 2 to PD 4 Drying and Conveying Systems
Figure 18
Setting List for Process Temperature Controller, Part No. A0555756 Cont’d.
Mode Parameter Setting range Default AEC setting
Expansion
SL-H Set Point Upper
Limit
SP Lower Limit +1 to Scaling Upper
Limit
1300 400.0
Expansion
SL-L Set Point Lower
Limit
Scaling Upper Limit to SP Lower Limit -200 0
Expansion CnEL PID/ON/OFF PID/ON/OFF PID Default
Expansion
SE ST Adaptive Tuning
(Fuzzy)
OFF/ON OFF Default
Expansion SE-b ST Stable Range 0.1 to 999.9
°C/F
15 Default
Expansion ALFA
α
0.01 to 1.00 0.65 Default
Expansion
AE-G AT Calculated
Gain
0.1 to 10.0 1.0 Default
Expansion
rESE Standby
Sequence Reset
Setting Method 0/1 0
Default
Expansion
rEE Automatic Return
of Display Mode
0 to 99 SEC 0 Default
Expansion AE-H AT Hysteresis 0.1 to 9.9% FS 0.2 Default
Expansion
LbAb LBA Detection
Width
0.0 to 999.9% FS 0.2 Default
Option Boards
Available Option Boards
Option Type RE232C RS-485 Event Input Transfer Output
Board Number E53-CK01 E53-CK03 E53-CKB E53-CKF
Mode Parameter Setting range Default AEC setting
Option Eu-A Multi-SP Function 0/1 0 Default
Option Eu-1 Event Input Assign 1 STOP/MAN STOP Default
Option SbCE Communication Stop Bit ½ BITS 2 Default
Option Len Comm. Data Length 7/8 BITS 7 Default
Option PrEY Commication Parity None/Even/Odd Even Default
Option 6PS Comm. Baud Rate 1.2/2.4/4.8/9.6/19.2 9.6 kbps Default
Option U-n6 Comm. Unit No. 0 to 99 0 Default
Option Er-E Transfer Output Type SP/SP-M/PV/O/C-O SP Default
Option Er-H Xfer Output Upper Limit 5 5 Default
Option Er-L Xfer Output Lower Limit 5 5 Default
Note: Use the Default setting for any setting not listed here.