Timeguard ETU17 - Manual (Page 7)

6
ii. Once the day option has been selected
press <Program> button briefly to select
hour time – display shows hour digits and
ON flashing. Press <Change> button to
advance hour setting. (Note: 2 days (Sat & Sun) shown as
examples of days set.)
iii. Minute Setting – Press the <Program>
button briefly to select the minutes –
display shows clock symbol and minute
digits flashing. Press the <Change> button
to advance the minutes setting. For rapid minute selection press
and hold down <Change> button. (Note: 16 hours shown as
example of hours set).
iv. Press <Program> button briefly –
clock is now set and display shows ready
for the first ON programme time.
v. Now set the hours and minutes as before.
The day(s) selected remains the same.
vi. Repeat steps i to v to set the remainder of the 5 programme
ON/OFF times and day(s) as required. Note: Any unused ON/
OFF programmes must be left blank and should be bypassed by
pressing and holding down the <Programme> button until the
display shows normal operating mode. Do not programme ‘0’s
into unused programmes.