Timeguard NTT01 - Manual (Page 3)

2
3. Installation:
We recommend that this unit be fitted by a
qualified electrician. Install in accordance
to wiring and current building regulations.
Please read the instructions carefully. If in
any doubt contact the Timeguard Helpline.
Important: Switch off mains electricity
before commencing work.
Remove the two bezel fixing screws, and remove
bezel from timer module and back plate. Separate
the timer module from the back plate, and remove
the wall fixing screws.
Ensuring that the free terminals on the back plate
are at the top, connect the installation wiring to
the terminal block, according to the legend on the
wiring label.
The earth wires should be connected to the wall
box earthing terminal, or should be connected
together using a single way connector block if
there is no suitable earth terminal in the back box.
fit the wall mounting screws through the back
plate into the wall box threaded holes, and tighten
until the back plate is firmly fastened.
fit the timer module to the back plate, ensuring
the time indicator is on the bottom right hand
side, and the locating holes on the timer are set
correctly on the pegs on the back plate.
fit the bezel over the timer module, and secure to
the back plate with the two screws provided.