Timeguard LEDMF100FL - Manual (Page 2)

1
Please read these instructions before installation and keep or give to the customer for future reference.
1. General:
The LEDMF50FL, LEDMF70FL and LEDMF100FL are high efficiency LED floodlights. They are suitable for
a wide range of outdoor locations: gardens, entrances, garages, outdoor parking areas etc. and can be
used to replace halogen, HID and other floodlights.
2. Location Selection:
• Suitable for outdoor use and for installation on walls and on the ground.
• Suitable for a wide range of locations: gardens, entrances, garages, outdoor parking areas etc.
• Check the surface and fittings will hold the weight of the product.
• Can be installed on surfaces of normal flammability e.g wood, plasterboard, brickwork
and other masonry.
• Do not install on flammable surfaces such plastics.
• Do not install on conductive or damp surfaces.
• Allow at least 0.5m between the luminaire and any illuminated surface.
• Allow plenty of space around the luminaire for air circulation.
• The luminaire is designed for connection to fixed wiring and must be connected to a suitable circuit
protected by an MCB or fuse.
3. Installation:
We recommend that this unit be fitted by a qualified electrician.
Install in accordance to current wiring and building regulations.
Please read the instructions carefully. If in any doubt contact the Timeguard Helpline.
• Important: Switch off mains before commencing work.
• Choose the location taking into account the points above.
• Using the mounting bracket as a template mark the fixing points and drill holes suitable for the chosen
fittings (not supplied).
• Fit the lamp to the selected surface.
• Connect the supplied wire to the terminals in a junction box with the required IP rating and connect the
incoming mains to the terminals in the junction box. Make sure the wire polarities are maintained.
Live
Brown or Red
Neutral Blue or Black
Earth Yellow/Green or Green
• Reconnect the mains power to test the luminaire.
• Adjust the angle of the luminaire so that it illuminates the required area and then tighten the fastenings
holding the bracket to the luminaire body.