Brother HL-2170W - Manual (Page 310)

CHAPTER 6 EPSON - 22
Select international character set
EscRn (27)(82)n <1Bh><52h>n
 This command selects one of the available international character sets, refer to the printer User Guide for
supported character sets.
 Each character set varies slightly from the others and contains a small number of special characters necessary
for printing in that particular language.
 The selection you make with this command does not affect any italic or graphics character table selection that
you may have made with the Esc t command.
 The character sets listed below, plus several others, can also be selected from the printer's control panel.
 The character sets available and the corresponding values of n are as follows:
US ASCII 0 Japanese 8
French I 1 Norwegian 9
German 2 Danish II 10
UK ASCII I 3 UK ASCII II 13
Danish I 4 French II 14
Swedish 5 Dutch 15
Italy 6 South African 16
Spanish 7
 If you have selected the graphics character table with the Esc t 1 command the following additional character
sets are available.
Norwegian set I 17 IBM set I 19
Norwegian set II 18 IBM set II 20
LPRINT CHR$(27); CHR$(82); CHR$(3); 'Select British char set
Select italic / graphics character table
Esctn (27)(116)n <1Bh><74h>n
 This command allows you to choose between two character tables - the italic character table and the graphics
character table.
 The two tables are shown in the Epson FX-850 section of the appendix at the end of this manual.
 Set n to 0 to select the italic character table. Character codes in the range 160 to 255 are now italic
characters.
 Set n to 1 to select the extended character table. Character codes in the range 128 to 255 are now foreign
language and graphics characters.
 You can still print italic characters using the Select Italic Mode, Esc 4, command even when you have
selected the graphics character table.