Brother TD-2120N - Manual (Page 91)

ESC/P Command Reference
- 85 -
5. Control Command Details
ESC i M 2D barcode (MaxiCode)
ASCII: ESC i M or m data
Decimal: 27 105 77 or 109 data
Hexadecimal: 1B 69 4D or 6D data
Format: ESC i M or m [Parameters] \ [Barcode data] \\\
(1) (2) (3) (4)
Parameters
(1) [Parameters]
If a value other than those listed is entered for a parameter, that parameter is specified with its default
value.
1. Symbol
type
[1-byte decimal] 0
[1-byte decimal] 1
[1-byte decimal] 2
Standard (default
value)
Full EEC
Structured carrier message
2. Structured
Append
setting [1-byte decimal] 0
[1-byte decimal] 1 With Structured Append (default value)
Without Structured Append
(2) \ (backslash)
Separator between parameters and barcode data
(3) [Barcode data]: Barcode data
The number of barcode data characters that can be entered is listed below.
Maximum Amount of Information Allowed
Symbol Type
Alphanumeric Characters Numbers
Standard 93 138
Full EEC 77 113
Structured carrier message 84 126
Note
The numbers of characters that can be entered (as listed above) are for when using only the
common character set (code set A in the MaxiCode specifications). The number of characters that
can be entered may decrease, depending on the characters that are used.