Brother NX-2000 - Manual (Page 7)

5
ENGLISH
Attaching the Circular Attachment
a
Place the circular attachment at left as shown
in the figure.
 The two tabs on the underside of the attachment will
drop down into corresponding holes in the needle
plate, so that the attachment lays flat on the bed of
your machine.
b
Insert the screw on the circular attachment in
the screw hole at the right of the needle plate
(a).
a Attachment Screw
c
Securely tighten the screw with the disc-
shaped screwdriver included in your
machine.
a Disc-shaped screwdriver
Sewing a Circle
a
Raise the handle.
b
Slide the indicator to match the desired size
of your circle.
30 40
Note
• Thread the machine needle before setting the pivot
pin into the circular attachment. Threading lever
may hit the pivot pin and damage the pin or the
machines threading mechanism.
Note
• Do not slide the indicator by holding onto the pivot
pin, doing so may cause the pivot pin to bend or
break.