Hyundai H-MS1104 - Manual (Page 14)

H-MS1104 ( www.hyundai-electronics.ru ) 14
LPCM OUTPUT
Select PCM frequency at 48 kHz or 96 kHz
Note: Some amplifiers don't support 96 kHz sampling and cause coaxial output abnormal. The initial
factory setup is 48 kHz.
Dolby digital setup
DUAL MONO
Stereo: stereo output signal,
L-Mono: left output signal,
R-Mono: right output signal,
Mix-Mono: left and right output average signal.
DYNAMIC
If watching large dynamic scope movie program at night, to select this mode you can reduce the volume to
a very low level, at the same time, to keep the fine details sounds. In this case, this doesn't disturb the
family and keep the quality sounds.
HDCD
You can select the digital filter Off, 1x, 2x. The initial factory setup is 1x.
Karaoke setup
Set the microphone ON or OFF and adjust the microphone volume and echo level.
Video setup
VIDEO OUTPUT
OFF: set video output to the composite.
YUV: set video output in analog component video format when connecting to Y/U/V terminals
P-YUV: set progressive YUV signals. Connection same as YUV.
RGB: set video output in Red/Green/Blue format when connecting to SCART terminals.
P-RGB: progressive RGB signals. Connection same as RGB.
Note: If the video setting differs with the physical connection, the screen may be without picture. In case
of no picture, you can reset the unit, then keep pressing V-MODE button until the picture is OK again.